fluidmaster

toilet rocks back and forth?

If your tank rocks back and forth the screws are most likely loose. Retighten or replace depending on damage.

PRODUCT SOLUTION



BOWL-TO-FLOOR BOLTS & SCREWS


LEVEL OF DIFFICULTY

TIME TO INSTALL

- 5 MINUTES

TOOLS NEEDED:

PRODUCT NEEDED:


Pliers PLIERS

Fluidmaster 7114 Bolts & Screws

Fluidmaster 7114 Bolts & Screws SEE PACKAGING  |  SEE IN-STORE DISPLAY
IF YOU ARE IN THE STORE, THIS ITEM IS LOCATED HERE


INSTALLATION INSTRUCTIONS:

Bolts in the back two holes secure floor flange. Screws in the front two holes secure toilet base to floor.

  1. Insert bolts, head down, into mounting slots on floor flange.

  2. Slide plastic retainer washer down threads to hold bolts in place. Place a new wax gasket (sold separately) onto bottom of toilet bowl.

  3. Line up holes in toilet base with bolts in floor flange. Place toilet on top of flange.

  4. Place brass washers, then nuts on bolts. Tighten. DO NOT OVERTIGHTEN or bowl may crack.

  5. Through front two holes on base, carefully drill 3/16" pilot/starter holes in floor.

  6. Insert screws. Place brass washers, then closed-end nuts over screws.

  7. Tighten nuts carefully with wrench. DO NOT OVERTIGHTEN or bowl may crack.

    If new bolt caps are needed, use Fluidmaster Model 7115 or 7116.

© 2011 Fluidmaster, Inc. All rights reserved. This document is not a substitute for the product instructions, which may be found at www.fluidmaster.com. Fluidmaster, Inc. shall not be liable for any damages resulting from failure to install or maintain the product in accordance with the product instructions, from abuse or misuse of the product, from use of non-Fluidmaster, Inc. parts, or from overtightening. Do not use in-tank drop-in toilet bowl cleaners containing bleach or chlorine.